The choice of Garages, Tyre Fitting Bays and Industry

When you need a large single phase air compressor which is quiet running, has a well balanced twin cylinder, quiet slow running, belt drive pump with fitted aftercooler, which is driven by a mighty 3HP 230v single phase motor mounted on to a large and portable 150 litre air receiver, then you need the industrial Wolf Dakota 150 from the Wolf Air Professional Range.

This compressor displaces an impressive 397 litres/ Min (14CFM) from its heavy duty, in-line twin cast iron cylinder pump and works up to 150psi. 

For regular use around the garage or workshop, this hard working machine operating up to 150psi will tackle all regular tasks in a busy garage or workshop from paint spraying to tyre changing and operating a wide range of popular air tools including Air Drills, Chisels, D/A Sanders, impact wrenches, ratchet nut runners etc. making the Wolf Dakota 150 the choice of professionals.

Fitted with an air outlet pressure regulator and twin outlet 1/4 inch BSP Uni Hi Flow quick release connectors, the Wolf Air Dakota 150 air compressor is a must for those needing a high performing, high-pressure stationary 230/240v air compressor for tough daily use – and with a full 2 year warranty, you can’t go wrong.

Technical Specification Summary:
- Fully Automatic Stop / Start Pressure Switch Control
- Air Displacement: 14CFM
- Pump: Twin Cylinder, In Line, Belt Drive Pump
- Maximum Working Pressure 150psi
- Motor: 3HP, 230/240v Single Phase
- Air Receiver: 150 litres capacity
- Fitted:  Air outlet pressure control regulator with gauge, 
              Air receiver pressure gauge, 
              Safety valve
              Air receiver moisture drain valve.
- Outlets: Two 1/4 inch BSP Uni Hi Flow quick release connectors
- Approx Dimensions: L x W x H:   1400 x 475 x 890mm
- Weight approx: 81Kg

Note: This item is extremely heavy and needs 2 people to assist the driver when unloading the delivery vehicle.

IMPORTANT NOTE:

These are Industrial motors which demand a high start-up power supply but should work satisfactorily from one of the following options:

Option #1: A 13amp plug and plugged into a standard 13amp socket on a 32amp Domestic Ring Main with no other significant power being drawn from that ring main whenever the compressor is in use.

Option #2: A 13amp dedicated power supply from the mains board.

Option #3: A 16amp dedicated power Supply from the mains board.

Well over 90% of users enjoy satisfactory service when operating the compressor in one of these ways.

In the event of a 13-amp fuse in the plug blowing, it will not be because there is a problem with the Compressor. It will be that that the motor is experiencing a voltage drop on start up or when it gets towards the higher pressures.

Power supply voltages vary around the Country and if the fuse blows when operating option #1 above, you may wish to try option #2 or better still use option #3 which will solve the matter.

Caution: Never run Compressors from an extension cable – this will cause operational difficulties and may even damage your motor.